News

The Appliance Buddy™ Plus AUTO is a 120 volt 20amp fully automatic 2-way switcher based on the original Dryer Buddy™ Plus AUTO. Can be used for any two Appliances and even Level 1 Tesla Charging. It allows you to share common 20amp 120v wall outlet with any other Appliance you have without having to flip any switches. Basic operation is simple, the Primary outlet is always live and the Switched outlet is only live when there is enough amperage available to run the second Appliance. Check them out here: https://www.bsaelectronics.com/collections/all/appliance-buddy

Sometimes you just need something custom! This adapter is amazing! It has a 14-xx universal plug and TWO 5-15 / 5-20 outlets! With this adapter you can connect two 240v compatible devices equipped with a 120v 5-15 or 5-20 plug to a any of three outlets, it will fit into the 14-50 outlets commonly found in RV parks as well as a 14-30 outlet which is the newer dryer outlet allowing you to take it on the road and plug into a friends newer dryer outlet. The EVSE and our electric vehicles don’t require the neutral line so this plug...

With the BSA Electronics 50amp Power Tunnel™ you can permanently install a code compliant Romex extension in your wall to pass 240v 50amp power from one room where your Outlet is located, to your garage where your Electric Vehicle is located. This is the bigger brother to the original BSA Electronics Power Tunnel™ 30amp kit Designed to extend your NEMA 14-50 (4-prong 240v 50amp, Electric Range Outlet) or NEMA 10-30 (3-prong 240v 50amp, older Electric Range Outlet), also available in NEMA 6-50 (3-prong 240v 50amp, Large Welder Outlet) 50AMP POWER TUNNEL™ 240 VOLT THROUGH WALL EXTENSION

The BSA Electronics Intellisplit™ - Intelligent Splitter Indoor version is a hardwired fully automatic 2-way switcher based on the original Dryer Buddy™ Plus AUTO. It allows you to share your dryer outlet with your EVSE without having to flip any switches. Basic operation is simple, the Dryer circuit is always live and the EVSE circuit is only live when there is enough amperage available to charge your EV. When the Dryer is off it is drawing little to no amps so the EVSE circuit is switched on allowing your EV to charge. If the Dryer is turned on at any time then the EVSE...

The BSA Electronics Intellisplit™ - Intelligent Splitter Outdoor version is a hardwired fully automatic 2-way switcher based on the original Dryer Buddy™ Plus AUTO. It allows you to share your dryer outlet with your EVSE without having to flip any switches. Basic operation is simple, the Dryer circuit is always live and the EVSE circuit is only live when there is enough amperage available to charge your EV. When the Dryer is off it is drawing little to no amps so the EVSE circuit is switched on allowing your EV to charge. If the Dryer is turned on at any time...